Anodized SunmeterThe new SUNMETER and LITEMETER Voltage cases are made of fully anodized aluminum for a more resistant product over time. The anodic oxidation is the electro-chemical process that generate an oxide film stably present on the metal surface.
In addition to the aesthetic improvement, anodizing increases the durability of the surface, the abrasion and corrosion resistance in environments like photovoltaic fields where there are obvious electrostatic and induced currents that cause galvanic corrosion.
Moreover, only for RS485 version, in the SUNMETER case has been added a M8 3-pin connector for getting direct input to the modules temperature sensor.
This will allow the installer to avoid the installation of a junction box which is usually installed immediately downstream of the female connector, thus allowing time saving and an increase reliability due to the lack of possible water leaks in the connections made for the temperature sensor of the modules.

This website uses cookies and allows third­party cookies. By pressing the OK button or taking any action on the website, you accept the use of these cookies. To learn more about how to change or deny the use of cookies please see our: Privacy policy

OK