Temmeter PRO

Temperature probe for photovoltaic modules

Temmeter ProTenmeter PRO is a ready-to-install PT100 thermal sensor with a stainless steel mounting system.

 

 

This Temmeter is a temperature sensor for photovoltaic modules, which is equipped with an aluminium bracket and a spring of adjustable lenght. That allows the probe to stay attached to each photovoltaic panel with the correct pressure. No need for adhesives and ease of installation.

Its main features are:

  • Speed of response to temperature variation (<5s., high thermal transmittance);
  • Measurement precision above the required standards (PT100  class A sensor );
  • Shielded cable.
Temmeter
TYPE OF PRODUCTTemperature ProbeTemmeter Pro
REFERENCE STANDARDIEC 60751 (class B)
OUTPUT(Analogical) Variation of impedance (PT100 Δ ± 0.6°C)
Sensor casingMetal with caps in white plastic, with neutral thermal behavior at direct irradiation
Type of sensorPlatinum Termal Resistor PT100 class B with high heat trasmittance
Response rate ΔT
PT100 dimensionsDiameter: 6 mm - lenght: 15 mm
Wire2m sheathed with stainless steel and plastic casing with high thermal resistance
Temperature range-50 /+300 °C
Precision± 0.6 °C
MaterialStainless steel AISI 316
2m with 2/3 poles, shielded, with external insulation UV and temp. proof
ConnectorM8 a 3 poles IP67 / loose pins (white - white - red)**
External dimensionDiameter 25mm; stirrup 25x30x30

** during the order please specify version (with connector M8 or loose pins)

This website uses cookies and allows third­party cookies. By pressing the OK button or taking any action on the website, you accept the use of these cookies. To learn more about how to change or deny the use of cookies please see our: Privacy policy

OK